In addition to excellent hydrophobic properties, it prevents premature deposition of dirt and has anti-reflective properties.

This product lowers the amount of dirt that settles on the car, and allows you to use your wipers less.

Glass surfaces in mechanical vehicles (windows, mirrors, headlights, sunroofs)

DURABILITY

Windscreen up to 24 months
Side windows and other glass areas 24-36 months

COVERAGE

25ml of G2 is sufficient to coat the windscreen, all side and rear screens of any vehicle twice.

KIT INCLUDES

2 x 12.5ml Clear Vision Products (G2a and G2b)
1 x Precision Applicator 8x4x3cm
1 x Suede Microfibre Applicator Cloth 10cm x 10cm

• Do not use the product in temperature below 10ºC!
• Do not expose the surface to sunlight.
• Make sure that the surface is not hot.
• Provide proper ventilation and fresh air.
• If the surface was strengthened by different water-proof products, you will need to remove them beforehand.

Step 1: Mixing.

1.  Mix the two bottles at an ambient temperature of between 10ºC and 30ºC (15-25ºC is the most optimal) in 1:1 ratio for at least 3 minutes. (pour one bottle into the other as per video)
2.  After that, mixture is ready to use.
3.  Before applying, the surface must be clean and at an ambient temperature of between 10ºC and 30ºC (15-25ºC is the most optimal).

Step 2: Cleaning the surface.

1.  Stability of the applied coating and its resistance to scratching, depends on how the product will be chemically bounded to the surface. That’s why it is extremely important to clean the surface before applying G2.
2.  Clean the glass with a de-greaser such as TENZI IPA Cleaner and wipe until dry. 

Step 3: Applying G2 product.

1.  Avoid direct exposure to sunlight.
2.  When applying the product to car windows, the complete window should be coated (outside facing edge)
3.  Apply prepared product (according to step 1) in the form of the thin film by using the applicator pad (equally, the TENZI Suede Microfibre Applicator Cloth can be used). It is recommended that when applying the product to the windscreen, due to the size, apply to one half of the windscreen and then buff off and then proceed to do the other side; this prevents drying out of the product. 
4.  DO NOT let the product dry off on its own and collect any excess with a clean paper towel.
5.  Fully buff and polish the surface with a clean delicate microfibre cloth.
6.  Hydrophobic effect is usually seen after 5-15 minutes (depending on atmospheric temperatures). TENZI recommended to leave the surface with applied film for about 30 minutes before getting wet and using wipers; from our tests, we however recommend leaving the surface with applied film for 12hrs without getting wet for it to fully cure and achieve its full potential.

Step 4: Rebuilding the surface that has been coated with G2 before.

1.  Film may be applied again according to steps 1-3.
2.  If glass surface was strengthened with other hydrophobic products, you will need to remove them, before applying G2.

SAFETY INFORMATION

Technical cards
Safety Data Sheets