This Flexipads Denim Orange Peel Removal pad you can now remove or substantially reduce orange peel in the top layer without sanding. While removing orange peel and deep defects you are also polishing the paint rather than leaving sanding marks which reduces the steps needed afterwards.
Size - 5" (135mm) pad Surface - Denim
Remove Orange Peel and deep defects while simultaneously polishing paint
Equivalent to 2000 grit sandpaper with out the dulling of paint and sanding haze
Remove Orange Peel without sanding
Orange peel removal without the haze generated by sanding
Breather perforations to avoid paint dust buildup on pad and help keep heat down
Polish the paint while removing the ridges of orange peel
Less dust and clean up prior to finishing polish directions:
Size: 6" (150mm) Diameter
Made in: Great Britain
Pore Size: 90ppi
Material: Denim Surface with Velcro backing
Directions for use:
Attach to Velcro backing plate on a Rotary polisher
Apply a few drops of polish to paint or pad according to your skills and preference
Work a 2' x 2' section or larger to keep heat down as needed but remember the larger the area the more time it will take to level orange peel and defects.
Begin working polish on low speed for a pass or so.
Step up speed to approx. 1200 rpm (adjust as needed)
With proper lighting observe the level of orange peel removal while you work
Apply more polish if needed or a spray of water on pad to re-activate lubricants
When satisfied with orange peel and defect removal slow speed, ending at 600 rpm as you finish down the polish
Refine finish with a foam pad or microfibre pad and polish
Add a small amount of dish washing detergent to a 5 gallon bucket and fill it with water.
Soak the dirty pad for up to 30 minutes.
After soaking, massage the pads to work out the caked in polish.
Squeeze out the soapy water.
Empty and refill the bucket with fresh water.
Rinse the pads in the bucket of fresh water, squeeze, and set aside to air dry.
Washing machines often do not remove all of the residue and some washing liquids leave behind small amounts of residue.
Tumble driers can deform the pads and sometimes even damage the cell structure and on microfibre pads, the heat will soften the glue which hold microfibre to its backing.
(Please check your Spam/Junk folder for notification and add us to your mailing list)
Thankyou for shopping with The Clay Cloth Company